Multi-housings made of polypropylene or PVDF for the installation of 3, 5, 7 or 12 fi lter cartridges in the lengths 10“, 20“, 30“ or 40“. The cover can be removed without tools, but with the aid of plastic star-grips. Apart from the connections for in- and outlet the housing has a ½“ vent plug as well as two ½“ drain plugs for dirt- and clean side. The connections for both in- and outlet are equipped with either a fl ange or GF connection piece which can be screwed on. Custom made equipment such as manometers or additional instrumentation as well as special inlet/outlet posi-tions and connection types are available on request. For higher pressures or higher temperatures covers and container fl ange with a stainless steel reinforcement are implemented. All housings undergo a compression test in the factory, before beingreleased for dispatch. Filter cartridge versions with center posts and plug-in adapters can be exchanged easily by screwing the nut on without having to remove the adapter from the intermediate plate. All general-use fi lter elements with double open ends can be used. If center posts are removed, fi lter cartridges with Code 0 or Code 5 adapters can be used. An additional centering and pressure device can be provided for multi-housings. This attaches the cartridges and prevents them from being pushed off the intermediate plate by pressure impacts which go against the fi lter direction.
Material |
Housing: polypropylene or PVDF |
In-/Outlet: |
See table
|
Vent |
½“
|
Drainage |
2 x ½“
|
Filter elements |
Code 0: 10“, 20“, 30“ or 40“ |
Pressure |
PP Housings: PVDF Housings: |
Temperature |
PP Housings: PVDF Housings: |
Flow rate | The maximum flow rate correlates to the nominal diameter of the housing connection and the characteristic curve of the flow rate of the chosen filter element. |